Bosch MCM3...AU, Instruction Manual

 7

en

 Operation

Shredding reversible disc – 

coarse/fi ne

for shredding vegetables, fruit 

and cheese, except for hard cheese 

(e.g. Parmesan).

Process at setting 1.

Designation on the reversible shredding disc: 

“2” for the coarse shredding side

“4” for the fi ne shredding side

Warning!

The reversible shredding disc is not suitable 

for shredding nuts. Shred soft cheese with 

the coarse side only at setting 2.

Reversible slicing/shredding disc 

for slicing and shredding fruit, 

 vegetables and cheese.

Process at setting 2. 

Note:

 Do not process any hard foods using 

the slicing/grating reversible disc as this may 

blunt the blade. Use the slicing  reversible 

disc (thick/thin) for this purpose.

Fig. 

C

■

Attach the bowl (arrow on bowl on dot 

on the appliance) and rotate as far as 

possible in a clockwise direction.

■

Insert tool holder into the bowl. 

Depending on the required use:

■

Place cutting disc on tool holder. Turn 

required slicing/shredding side face up. 

Place disc on the disc holder so that the 

drivers on the tool holder grip the opening 

in the discs.

■

Attach lid with pusher (match arrow on lid 

to arrow on bowl) and rotate in a clock-

wise direction. Lid lug must be located fully 

in the slot in the bowl handle.

■

Insert the mains plug.

■

Set the rotary switch to the desired setting.

■

Fill with contents which are to be sliced or 

shredded.

■

When adding contents which are to be 

sliced or shredded, apply only light pres-

sure to the pusher. Remove the pusher 

and add ingredients through the feed tube.

Warning!

Empty the bowl before it becomes so full 

that the cutting or grating contents reach the 

carrier disc.

After using the appliance

■

Set the rotary switch to 

P

.

■

Remove mains plug.

■

Rotate the lid in an anti-clockwise direction 

and remove.

■

Remove tool:

Take tool holder together with universal 

blade, whisking disc or kneading hook out 

of the bowl. Remove the tools from the tool 

holder.

■

Take out the cutting discs by the plastic 

stud in the centre. Take tool holder out of 

the bowl.

■

Rotate bowl anti-clockwise and remove.

■

Clean all parts, see “Cleaning and 

servicing”.

Blender

Blade insert with blender/cutting blade for 

mixing liquid or semi-solid food, for cutting/ 

chopping raw fruit and vegetables, for 

puréeing food.

W

Risk of injury from sharp blades / 

rotating drive!

Never place fi ngers in the attached blender! 

Do not remove/attach the blender until the 

drive is at a standstill. Do not touch blades of 

the blade insert with bare hands. Clean them 

with a brush.

W

Risk of scalding!

If processing hot liquids, steam escapes 

through the funnel in the lid. Add a max. 

0,4 litres of hot or frothing liquid.

Warning!

Blender may be damaged. Do not process 

deep-frozen ingredients (except ice cubes). 

Do not operate blender when empty.

Fig. 

D

■

Place seal on the blade insert. Ensure that 

the seal is positioned correctly.

Important information

If the seal is damaged or not correctly 

 positioned, liquid may run out.

■

Insert blade insert with blender/cutting 

blade 

p

 into the blender jug and lock 

anti-clockwise (

m

).

■

Turn blender jug over (blade insert face 

down).

MCM3_AU_8001032515.indb   7

14.01.2016   11:19:22