Robert Bosch Hausgeräte GmbH
11
This will prevent residue from drying on and
attacking the plastic (e.g. by essential oils in
herbs).
The blender jug, lid and funnel are
dishwasher-proof.
Do not clean blade insert in the dishwasher,
but under running water. Do not leave in
water!
Tip: Pour a little water and washing-up liquid
into the attached blender. Switch on at
setting M for several seconds. Pour out the
water and rinse the blender with clean water.
Taking the blender apart
Fig.
Upon the wings, rotate the blade insert
in an anti-clockwise direction.
The blade insert is released.
Take blade insert out and remove
sealing ring.
Putting the blender together
Apply sealing ring on blade insert.
Insert blade insert from below into
blender jug.
Firmly screw on the blade insert
by the wings in a clockwise direction.
Rotate the blade insert at least until
a wing covers the mark on the blender
jug (position –> Fig.
-6).
Cleaning the universal cutter
It is recommended to clean the universal
cutter immediately after use. This will prevent
residue from drying on and attacking the
plastic
(e.g. by essential oils in herbs).
The lid is dishwasher-proof.
Do not clean jug and drive in the dishwasher,
but under running water using a brush.
Do not leave in water!
To dry, place the jug and drive face up.
Storage
Fig.
Store tools and cutting discs in the acces-
sories bag.
Always store the universal blade with the
blade guard attached.
Stow the cable by pushing it carefully into
the cord store.
Troubleshooting
Base unit
Fault:
Appliance does not work.
Possible cause:
The appliance was overloaded (e.g. tool
jammed by food) and the electronic fuse
has tripped.
Remedial action:
Set the rotary switch to 0/off.
Remove mains plug.
Eliminate the cause of the overload.
Switch the appliance on again.
Possible cause:
An attempt was made to attach the bowl
or blender to the appliance while switched
on.
Remedial action:
Set the rotary switch to 0/off.
Attach the bowl or blender.
Switch the appliance on again.
en
Risk of injury from sharp blades!
Do not touch universal cutter blade with bare
hands. Clean them with a brush.
Risk of injury!
When the appliance is not in use, pull out the
mains plug.
Risk of injury!
Before rectifying a fault, pull out the mains
plug.
Important information
The Operating indicator flashes if
the appliance has been operated
incorrectly or the electronic fuse has
tripped or the appliance is defective.
