User Manual | Mitchell Diagnostics | Scan Tool | 10 | en
©Mitchell International, Inc.
581624 | REV. B | 06.2017 | APDMD032018
9:40
Today is Thu, 04 Jan 2018.
Saved Diagnostic Data
Browser
Select Vehicle
Settings
OBDII
Heavy Duty
MAIN MENU - Tap Below To Begin Your Diagnostic Experience
DEMO
ss01826
Provide Power to Scan ToolI
ss01716
1
2
3
MD-200
Scan Tool Cable Connections
1. OBD II / DLC cable
2. 12 volt power cable (Use with vehicles that do
not supply power through DLC)
3. Scan tool
Power via vehicle DLC
1. Connect the OBD II / DLC cable to the scan tool.
2. Connect the OBD II / DLC cable to the DLC on
vehicle. Located within 18 inches (45.7 cm) of
steering wheel. Typically located on the driver’s
side, under dash.
3. Turn ignition ON.
Non-powered vehicle DLC setup
Some vehicles do not supply power through DLC. In
this case use the following procedure.
1. Connect OBD II / DLC cable to scan tool.
2. Connect OBD II / DLC cable to DLC on vehicle.
Typically located on the driver’s side under the
dash.
3. Connect the 12 volt power cable to the scan tool
power port.
4. Connect the 12 volt power connector to the
vehicle power outlet
5. Turn ignition ON.
ss01717
2
1
3
MD-200
Scan Tool Connected to Vehicle
1. OBDII/DLC Cable
2. DLC
3. Scan Tool