User Manual | Mitchell Diagnostics | Scan Tool | 21 | en
©Mitchell International, Inc.
581624 | REV. B | 06.2017 | APDMD032018
DTCs Modes 3, 4, 5, A Button Definitions
Clear DTCs Button
The Clear DTCs button is used to clear
codes and remove all but permanent
DTCs on the selected controller. To clear
codes, complete the following:
NOTE:
• Clearing DTCs will erase current
Mode 1 Readiness monitor
information and require the user go
through necessary drive cycles over
again. So, if Mode 1 information
needs to be reviewed, be sure to view
it before clearing codes.
• If a code will not clear, turn the
ignition off for at least 10 seconds;
turn it back on to KOEO, then retry.
Some controllers will go to sleep after
a period of inactivity and prevent
clearing DTCs. This key cycle may be
needed when attempting to
communicate with other controllers
after a period of time on a different
controller.
Refresh DTCs Button
Tapping the Refresh button initiates a
fresh scan of DTCs from the vehicle.
Share DTCs Button
Tapping the Share button opens the
app and initiates options. Depending on
what’s available at the time. Share a list
containing all the DTCs set by email or
Bluetooth or USB.
Menu Button
Tapping the Menu button displays a pop-
up link that takes the user to help content
related to reading DTCs.
Note: An active internet connection will be
required.
Use Metric Units
Selecting Metric Units will switch from
English/Standard Units to Metric Units.
Use English/Standard Units
Selecting English/Standard Units will
switch from Metric Units to English/Stan-
dard Units.
Take Screen Capture
Selecting Take Screen Capture will save a
copy of the current open screen.
Oxygen (O2) Sensors
Mode 5 views O2 sensor monitor test results.
Generic OBDII
READINESS MODE 1
DATA STREAM MODE 1
FREEZE FRAME MODE 2
O2 SENSORS MODE 5
SPECIAL TESTS MODE 8
NON-CONTINUOUS TESTS
MODE 6
DTCs MODES 3, 4, 7, A
VEHICLE INFO MODE 9
Menu
Share
Oxygen Sensor Tests (Mode 5)
Description
Min
Value
Max
Units
0.000
0.003
1.275
V
0.000
0.003
1.275
V
0.000
0.003
1.275
V
0.000
0.003
1.275
V
Bank 1 Sensor 1
Lean To Rich Sensor Threshold Voltage
High Sensor Voltage For Switch Time
Calculation
Minimum Sensor Voltage For Test Cycle
Maximum Sensor Voltage For Test Cycle
ss02724
Mode 5 displays the average of the O2 sensor
monitor test results measured over a period of time.
The parameters of this measurement vary between
manufacturers. It may be necessary to run the
vehicle for a period of time to allow the O2 sensors
to fully warm up and begin operating as intended.
Oxygen (O2) Sensors Button Definitions
Menu Button
Tapping the Menu button displays a
pop-up link that takes the user to more
buttons.
View Help
Selecting View Help will open an online
user manual.
Use Metric Units
Selecting Metric Units will switch from
English/Standard Units to Metric Units.
Use English/Standard Units
Selecting English/Standard Units will
switch from Metric Units to English/Stan-
dard Units.
Take Screen Capture
Selecting Take Screen Capture will save a
copy of the current open screen.
