User Manual | Mitchell Diagnostics | Scan Tool | 30 | en
©Mitchell International, Inc.
581624 | REV. B | 06.2017 | APDMD032018
Ford/Lincoln/Mercury
When connected to a Ford/Lincoln/Mercury vehicle
a pop up menu allowing the user to choose between
specific special tests.
4:09
2012 Ford Mustang Shelby GT500 5.4L
Today is Tue, 09 Jan 2018.
CHECK
DTC
CHECK
DTC
Read DTCs
All Systems
Diagnostic information
Read DTCs
Select Systems
Automated System Test
Data Stream
Maintenance Tests
Special Tests
Enhanced OBDII
ss02840
1. Select Read DTCs from the screen.
2012 Ford Mustang Shelby GT500 5.4L
Please select one or more controllers and tap ‘Continue’ to start DTC scan.
Continue
PCM
ABS / TRACTION CONTROL
GEM MODULE / TPMS
AIRBAG
OCCUPANT CLASSIFCATION
Deselect All
Select All
ss02745
2. Select the desired vehicle controller then select
continue.
Diagnostic Trouble Codes
2012 Ford Mustang Shelby GT500 5.4L PCM
Menu
Select Option
Read DTCs
KOEO
KOER
Reset KAM
ss02746
3. Tapping an option in the menu takes the user to
that test. Follow the prompts on the screen.
Menu
Current Codes
2012 Ford Mustang Shelby GT500 5.4L PCM
B1207-00
B1200-00
B10A2-00
Crash Input
Crash Input Mismatch - CAN
Inactive Hardwired Active
Crash Input Hardwired Signal
DTC Info
Share
Read
Clear
Self-Diag
Save
Diagnostic Trouble Codes
DTC Info
DTC Info
ss02747
4. DTCs will be read from the selected vehicle
controller.
• Select a listed DTC for Related Diagnostic
Information See Diagnostic Information section
• If a DTC has Code Criteria available there will
be an “*” next to the DTC.
Manual DTCs
Certain vehicles do not support standard DTC
protocol and will require a manual process for
retrieving and clearing codes.
Menu
Diagnostic Trouble Codes
2002 Subaru Forester Base 2.5L ABS
1) Take out diagnosis connector from side of driver’s seat heater unit.
2) Turn ignition switch Off.
3) Connect diagnosis connector terminal 6 to diagnosis terminal.
4) Turn ignition switch On.
5) ABS warning light is set in the diagnostic mode and blinks to identify trouble codes.
6) After the start code (11) is shown, the diagnostic trouble codes (DTC) will be shown in order
of the last information first. These repeat for a maximum of 3 minutes.
7) NOTE: When there are no diagnostic trouble codes (DTCs) in memory, only the start code (11)
Share
Read
Clear
Save
Manual Codes Procedure
Library
ss02748
1. Follow the prompts on the screen for retrieving
DTCs.