User Manual | Mitchell Diagnostics | Scan Tool | 42 | en
©Mitchell International, Inc.
581624 | REV. B | 06.2017 | APDMD032018
Key Programming
Displays instructions for the selected vehicle for
programming a key.
1. Select Key Programming from the Diagnostic
Information screen.
Key Programming
2004 Ford F-150 XL 5.4L ABS (4WABS)
Menu
Battery Replacement
Immobilizer
See Image
Battery Replacement
Remote Alarm/Central
Locking
ss02807
2. Follow the prompts on the screen to program a
key and or replace battery in key.
Battery Disconnect
Displays procedures for disconnect the battery on
the selected vehicle.
1. Select Battery Disconnect from the Diagnostic
Information screen.
Battery Disconnect
2004 Ford F-150 XL 5.4L ABS (4WABS)
Menu
Battery Location
General information
See image
122448
Battery Location
Before Battery
Disconnection
Before Battery
Connection
ss02808
2. Follow the prompts on the screen to disconnect
and connect the battery.
3. Follow procedures for updating vehicle systems
after battery has been disconnected.
TMPS Quick Info
Describes the operating procedures for the Tire
Pressure Monitor System (TPMS) for the selected
vehicle.
1. Select TMPS Quick Info from the Diagnostic
Information screen.
TPMS Quick Information
2009 Honda Accord LX 2.4L TIRE PRESSURE MONITOR
Menu
DESCRIPTION
RESET PROCEDURES...
System Description: When the vehicle speed exceeds 28 mph (45 km/h),
the Tire Pressure Monitor System (TPMS) Control Unit monitors the
pressure in all four tires and the system itself. System Operation: The
TPMS has two LED indicators that are part of the gauge module; a low-
pressure indicator and a system indicator. When the TPMS Control Unit
detects low pressure in a tire (or a problem in the system) it turns on the
appropriate indicator(s). If low tirw pressure is detected, the low pressure
indicator comes on. If a problem in the system is detected, the TPMS
indicator comes on. If low tire pressure and a problem in the system are
detected, only the TPMS indicator comes on. With the system functioning
properly, the low pressure indicator should come on when the ignition is
turned ON. It should then go off 2 seconds later. If this is not the case, there
Is a problem with the system. If the system detects low pressure in any tire,
Description
RESET TRIGGER
TORQUE SPECS
TPMS SENSOR PART
NUMBER
ss02809
2. Follow the prompts on the screen to reset the tire
pressure monitors.
Diagnostic Information Button Definitions
Change Controller Button
Tapping the Change Controller button
displays the select controller screen.
Menu Button
Tapping the Menu button displays a pop-
up link that takes the user to help content
related to reading DTCs.
Note: an active internet connection will be
required.
View Help
Selecting View Help will open an online
user manual.
Take Screen Capture
Selecting Take Screen Capture will save a
copy of the current open screen.
Automated System Test
Overview
The Automated System Test (AST) will scan all
available controllers on the selected vehicle for
Modes 1-7.
Depending on the vehicle, the handset may ask
qualifying questions concerning particular controller