6.4
Transport the Motor-Pump Unit with Cranes or Lifting Tools
The transport with cranes or lifting tools may only be done with suitable lifting
means, like e.g. lifting belts, belts and chains. At delivery, the motor-pump
unit is provided with lifting points on the pump and on the electro motor, see
the following table:
Component
Ring screws DIN580
MSK101
2x M8
PGM4
1x M8
Tab. 6-4:
Lifting points
For further information about carrying capacity of the ring screws
refer to the DIN580/092010 standard.
●
For lifting, use the provided positions or lifting points.
●
Always fasten the lifting means on 2 lifting points on the motor-pump
unit. Never lift the motor-pump unit on one lifting point.
●
Do lifting and lowering of the motor-pump unit slowly and carefully.
Fig. 6-1:
Lift MPAS1 (1)
DOK-SYTROX-MPAS1******-IT01-EN-P
Rexroth Sytronix SvP 70xx Motor-Pump Unit MPAS1
Bosch Rexroth AG
35/83
Transport and Storage
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
