16
Robert Bosch Hausgeräte GmbH
Before replacing accessories or additional parts, which move during
operation, switch off the appliance and disconnect from the power
supply. Connect and operate the appliance only in accordance with the
specifications on the rating plate. Only use indoors. Do not use the
appliance if the power cord and/or appliance are damaged.
Always disconnect the appliance from the supply if it is left unattended
and before assembling, disassembling or cleaning.
Do not place the power cord over sharp edges or hot surfaces.
To prevent injury, a damaged power cord must be replaced by the
manufacturer or his customer service or a similarly qualified person.
Only our customer service may repair the appliance.
,
Safety instructions for this appliance
Risk of injury
Risk of electric shock!
Do not insert mains plug until all preparations for working with the
appliance are complete.
Never immerse the base unit in liquid or hold under running water.
Do not use a steam cleaner.
Do not adjust the swivel arm while the appliance is switched on.
Wait until the drive has come to a standstill.
Use only the rotary switch to switch the appliance on or off.
When the appliance is not in use, pull out the mains plug.
Before eliminating a fault, pull out the mains plug.
Risk of injury from the rotating tools!
While the appliance is operating, never place fingers in the mixing
bowl. Attach the cover (11) before operating the appliance!
Do not change tools until the drive has come to a standstill – when the
appliance is switched off, the drive continues running briefly and stops
in the tool change position. Do not move the swivel arm until the tool
has come to a standstill.
For reasons of safety the appliance may only be operated when
unused drives have been covered with drive guards (4, 7).
Before attaching/removing the continuous-feed shredder, wait until the
drive has come to a standstill and pull out the mains plug.
Do not reach into the feed tube.
Risk of injury from sharp blades!
Do not grip the sharp blades or edges of the cutting discs. Take hold
of cutting discs by the edge only.
Do not touch blender blades with bare hands. Clean them with a brush.
en
Downloaded from www.vandenborre.be
Summary of Contents for mum53 series
Page 57: ...D o w n l o a d e d f r o m w w w v a n d e n b o r r e b e ...
Page 58: ...D o w n l o a d e d f r o m w w w v a n d e n b o r r e b e ...
Page 59: ...D o w n l o a d e d f r o m w w w v a n d e n b o r r e b e ...
Page 60: ...D o w n l o a d e d f r o m w w w v a n d e n b o r r e b e ...
