Basic operation
en
45
Cable length
Adjust the length of the power cable
to your needs.
Adjusting cable length via cable
rewinder
1.
Pull the power cable out to the re-
quired length and slowly let go.
2.
To shorten the cable,
‒
pull the cable,
‒
allow the cable to wind up,
‒
pull the cable out again.
Note:
Do not push the cable in by
hand. If the cable jams, pull right out
and let it wind up again.
Moving the swivel arm
1.
Press the release button and raise
the swivel arm until it engages.
→ Fig.
a
The swivel arm is fixed in posi-
tion 2.
2.
Press the release button and move
the swivel arm down until it en-
gages in the vertical position.
→ Fig.
a
The swivel arm is fixed in posi-
tion 3.
Inserting bowl
1.
Place the bowl in the base unit.
→ Fig.
Use the recesses on the base unit.
2.
Turn the bowl anticlockwise until it
engages.
→ Fig.
Removing bowl
▶
Turn the bowl clockwise and re-
move.
→ Fig.
Inserting tools
1.
Select the tool required.
→
2.
Press the tool into the main drive
until it engages.
→ Fig.
3.
To insert the kneading hook:
‒
Insert the kneading hook with
the protective cap fitted in the
main drive.
‒
Turn the protective cap until the
kneading hook engages fully.
The protective cap must cover
the main drive completely.
Removing tools
▶
Pull the tool completely out of the
drive.
→ Fig.
Attaching bowl lid
Requirements
¡
The required tool is used here.
¡
The bowl has been inserted.
¡
The swivel arm is closed.
1.
Press the release button, raise the
swivel arm slightly and hold in
place.
→ Fig.
2.
Lift the lid slightly at the front, slide
fully onto the bowl and set down.
→ Fig.
The filling shaft must face towards
the front.
3.
Push the swivel arm down until it
engages.
→ Fig.
Removing bowl lid
1.
Press the release button, raise the
swivel arm slightly and hold in
place.
