en
Basic operation
36
▶
Before changing tools or cleaning
the appliance, switch off and dis-
connect it from the mains.
▶
Only use the tools when the bowl
is inserted, the lid is fitted and the
drive covers are in place.
▶
Never open the swivel arm during
processing.
Requirements
¡
The bowl has been inserted.
¡
The required tool is inserted.
1.
Add the ingredients to the bowl.
2.
Press the release button and push
the swivel arm down until it en-
gages.
3.
Insert the mains plug.
4.
Set the rotary switch to the re-
quired speed.
→ Fig.
5.
Process the ingredients until you
achieve the required result.
6.
Set the rotary switch to
.
Wait until the appliance stops.
7.
Unplug the mains plug.
Tips
¡
You can change the speed at any
time during processing or interrupt
processing.
¡
Clean all parts immediately after
use so that residues do not dry on.
Adding more ingredients
1.
To add ingredients during pro-
cessing, use the filling shaft in the
lid.
→ Fig.
2.
To add large quantities, set the
rotary switch to
.
Wait until the appliance stops.
3.
Remove the bowl lid.
→
4.
Add the ingredients to the bowl.
5.
Attach the bowl lid.
→
6.
Process the ingredients until you
achieve the required result.
Using instantaneous switching
1.
Set the rotary switch to and
hold.
→ Fig.
a
The ingredients are processed at
maximum speed.
2.
Release the rotary switch.
→ Fig.
a
The rotary switch springs to
.
a
Processing stops and the drives
move to the parked position.
Tip
Instantaneous switching is especially
suitable when using the following
accessories:
¡
Blender attachment
¡
Multi-chopper set
¡
Multi-blender attachment
Drive cover
Remove the protective cover to use
accessories on drive 2 or 3.
Removing drive cover
1.
Lift the protective cover of drive 2
by the side lug and remove.
→ Fig.
2.
Pull up the protective cover for
drive 3 and remove.
→ Fig.
Fitting drive cover
1.
Position the protective cover for
the drive 2 and press in place
firmly.
→ Fig.
2.
Position the protective cover for
the drive 3 and press in place
firmly.
→ Fig.
Markings
and
must match
up.
Summary of Contents for MUMS2 Series
