8
en
After using the appliance
■
Insert the bowl:
– Tilt the bowl forwards and then set it
down.
– Turn anti-clockwise until it locks into
place.
■
Press release button and move
multi-function arm to position
3
.
■
Remove drive cover from the
drive of the continuous-feed shredder
(Fig.
D
-5a)
.
■
Hold disc holder at the lower end,
ensuring that the two tips are face up.
■
Carefully place the cutting disc onto the
tips of the disc holder
(Fig.
D
-6a)
. In the
case of reversible discs, ensure that the
required side is face up.
■
Grip disc holder at the upper end and
insert into the housing
(Fig.
D
-6b)
.
■
Attach the cover (note mark) and turn all
the way in a clockwise direction.
■
Place continuous-feed shredder on
the drive and rotate all the way in a
clockwise direction, as illustrated in
Figure
D
-8
.
■
Insert the mains plug.
■
Turn rotary switch to recommended
setting.
■
Put food to be processed in the feed
tube and push down with the pusher.
Warning!
Prevent the cut ingredients from building up
in the outlet opening.
Tip:
To ensure even cutting results, process
thin ingredients in bunches.
Note:
If the food to be processed sticks in
the continuous-feed shredder, switch food
processor off, pull out mains plug, wait until
the drive comes to a standstill, remove
cover from the continuous-feed shredder
and empty feed tube.
After using the appliance
■
Switch off the appliance with the rotary
switch.
■
Remove mains plug.
■
Rotate the continuous-feed shredder in
an anti-clockwise direction and remove.
■
Rotate the lid in an anti-clockwise
direction and remove.
■
Remove disc holder with disc. To do
this, press finger from below against the
drive shaft
(Fig.
E
)
.
■
Clean all parts, see “Cleaning and
servicing”.
Cleaning and servicing
W
Risk of injury
Do not grip the sharp blades or edges of the
cutting discs. Take hold of cutting discs by
the edge only.
Warning!
Do not use abrasive cleaning agents.
Surfaces may be damaged.
All parts of the continuous-feed shredder
are dishwasher-proof.
Tip:
To remove the red film after processing
e.g. carrots, pour a little cooking oil
on a cloth and rub the film off the
continuous-feed shredder (not the cutting
discs). Then rinse the continuous-feed
shredder.