5
Getting to know your appliance
The instruction manual is the same for various different hobs.
An overview of the models with their dimensions is given on
page 2
.
The control panel
Controls
When you touch a symbol, the respective function is activated.
Notes
■
The settings will remain unchanged if you touch several
symbols at once. This allows you to wipe up spills on the
control panel.
■
Always keep the controls dry. Moisture reduces their
effectiveness.
The hotplates
Residual heat indicator
The hob has a two-stage residual heat indicator for each
hotplate.
If
•
appears in the display the hob is still hot. It may be used,
for example, to keep a small meal warm or to melt cooking
chocolate. As the hotplate cools down further, the display
changes to
œ
. The display remains lit until the hotplate has
cooled sufficiently.
Power cut
If there has been a power cut, the residual heat indicator
switches back on automatically. The indicator flashes for
approximately 30 minutes. The flashing stops if you briefly
switch the hotplate on again.
Setting the hob
This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.
Switching the hob on and off
You can switch the hob on and off with the hotplate controls.
When the hob is switched on, the heat setting display lights up.
&RQWUROVIRU
p
H[WHQGHGFRRNLQJ]RQH
s
GXDOFLUFXLWKRWSODWH
RQKRWSODWHVZLWKH[WHQGHGFRRNLQJ]RQH
'LVSOD\VIRU
³
É
KHDWVHWWLQJ
¤
UHVLGXDOKHDW
©
HOHFWURQLFERLOVWDUWFRQWURO
&RQWUROIRU
Í
GXDOFLUFXLWKRWSODWH
&RQWUROIRU
,
FKLOGSURRIORFN
Hotplate
Activating and deactivating
$
Single-circuit hotplate
ð
Dual-circuit hotplate
Touch the
ñ
symbol
æ
Extended cooking zone
Touch the
é
symbol
ë
Dual-circuit hotplate with
extended cooking zone
Touch the
ë
symbol; the 2nd filament circuit is activated
Touch the
é
symbol; the extended cooking zone is activated
When the hotplate is activated: the corresponding indicator lights up.
When the hotplate is switched on: the last selected size is automatically selected again
