580000 | REV. A | 04.2017
Bosch Automotive Service Solutions Inc.
OBD 2220
Info Scan
| User guide | 23 | en
MIL is ON
MIL lamp should be ON if
engine is running
Press ENTER to continue
Rd\Er
3. Return to Diagnostic Menu.
•
Press
.
5.5
State OBD Check
The State OBD Check function is used to display a basic
status of the vehicles OBD system.
•
Malfunction indicator lamp (MIL) status
•
Codes found
•
I/M monitors
Erase Codes deletes DTCs and resets I/M monitors from
vehicle’s computer module(s).
The State OBD Check function has the following areas:
•
MIL Status ON or OFF
•
Number of Codes Found
•
Number of Monitors OK
•
Number of Monitors Inc
•
Number of Monitors N/A
State OBD Check should be done with the key on
engine running (KOER) due to showing MIL status.
The number of codes found are OBDII/EOBD confirmed
codes and permanent codes. Pending codes are not
included.
The number of monitors that are either ok, inc, or na are
only Since DTCs Cleared and not This Drive Cycle.
Refer to Read Codes and I/M Monitors for more
detailed information about the results.
From Diagnostic Menu:
1. Select State OBD Check.
•
Use the
and
keys until State OBD
Check is highlighted.
•
Press
.
Diagnostic Menu
Read Codes
Erase Codes
MIL Status
State OBD Check
View Data
Record Data
View Freeze Data
Drive Cycle Monitor
Rd\Er
I/M Monitors
2. View State OBD Check display.
State OBD Check
Codes Found
Monitors OK
Monitors Inc
Monitors N/A
MIL Status
18
3
5
3
ON
Rd\Er
3. Return to Diagnostic Menu.
•
Press
.
5.6
View Data
The View Data function allows real time viewing of the
vehicle’s computer module’s parameter identification
(PID) data. As the computer monitors the vehicle, infor-
mation is simultaneously transmitted to scan tool.
View Data allows the following items to be viewed on
the scan tool:
•
Sensor data
•
Operation of switches
•
Operation of solenoids
•
Operation of relays
Apart from Read Codes, View Data is the most useful
diagnostic function for isolating the cause of a vehicle
operation problem.
From Diagnostic Menu:
1. Select View Data.
•
Use the
and
keys until View Data is
highlighted.
•
Press
.
Diagnostic Menu
Read Codes
Erase Codes
MIL Status
State OBD Check
View Data
Record Data
View Freeze Data
Drive Cycle Monitor
Rd\Er
I/M Monitors
2. Observe while the scan tool validates PID list.