en | 2 4 | User guide |
OBD 2220
Info Scan
580000 | REV. A | 04.2017
Bosch Automotive Service Solutions Inc.
Validating PIDs
Validating PID List
PID 7/329
Please Wait
•
PID MAP validation is the tool asking the vehicle
which PIDs are supported. See “7
Appendix A—PID Definitions” on page 33 for a
complete list of PIDs supported by the tool.
•
Multiple PIDs may be sent if vehicle is equipped
with more than one computer module (for
example a powertrain control module [PCM]
and a transmission control module [TCM]). The
scan tool identifies them by their identification
names (ID) assigned by manufacturer (i.e. $10
or $1A).
•
If one or more control module stops responding,
the scan tool displays a message.
–
If continuing, dashes will replace data in
right-hand column.
–
If NO is selected, the scan tool attempts to
re-establish communication with that mod-
ule.
From Select Data to View menu:
1. Select Entire Data List.
•
Use the
and
keys until Entire Data List
is highlighted.
•
Press
.
Select Data to View
Long PID Names
English/Metric
Entire Data List
Rd\Er
2. View PIDs on scan tool.
•
Use the
and
keys.
ABSLT TPS(%)
CALC LOAD(%)
COOLANT(°C)
ENG SPEED(RPM)
EQ RATIO11
FUEL SYS 1
FUEL SYS 2
IAT(°C)
IGN ADV(°)
0.0
0.0
-40
0
1.999
N/A
N/A
-40
0.0
LT FTRM1(%)
0.0
Throttle Position
•
See “7 Appendix A—PID Definitions” on page
33 for PID definitions.
•
If the
icon displays while a PID is selected
press
to view graph.
•
Press
to pause the graph. Press
again
to continue graphing.
3. Return to PID screen.
•
Press
.
4. Return to Select Data to View menu.
•
Press
.
5. Return to Diagnostic Menu.
•
Press
.
5.7
Record Data
The Record Data function records PIDs while vehicle is
parked or being driven. The Record Data function is
mainly used for diagnosing intermittent driveability
problems that cannot be isolated by any other method.
The recording time varies. A recording consists of frames
of data before the trigger and several frames after the
trigger.
CAUTION
Two people must be in vehicle when driving.
One to drive and the other to operate the
scan tool.
From Diagnostic Menu:
1. Select Record Data.
•
Use the
and
keys until Record Data is
highlighted.
•
Press
.