580000 | REV. A | 04.2017
Bosch Automotive Service Solutions Inc.
OBD 2220
Info Scan
| User guide | 25 | en
Diagnostic Menu
Read Codes
Erase Codes
MIL Status
State OBD Check
View Data
Record Data
View Freeze Data
Drive Cycle Monitor
Rd\Er
I/M Monitors
2. Follow all instructions on display.
•
The scan tool can maintain only one recording.
Make sure to thoroughly review old recording
before erasing.
•
If a recording currently exists in memory, a
message prompting to erase data is displayed.
Record Data
Previous recording in
memory.
Do you want to erase it and
make a new one?
No
Yes
•
Scan tool validates list of global PIDs from
vehicle.
Validating PIDs
Validating PID List
PID 7/329
Please Wait
3. Press
to begin recording.
Recording
Collecting pretrigger data
Press ENTER to trigger
recording
•
Data continues to be saved until either:
–
Record memory is full.
–
Operator presses
.
Recording
Collecting data for frame #2
Press ENTER to end recording
•
Scan tool recording times vary. A recording
consists of frames of data before trigger and
several frames after trigger.
4. After recording, scan tool displays a prompt to
Playback Data.
Record Data
Playback data?
No
Yes
•
Select NO to return to Diagnostic Menu.
•
Select YES to display recorded data.
•
Refer to “Recording” on page 14 for instruc-
tions on how to play back data.
5.8
View Freeze Data
When an emission-related fault occurs, certain vehicle
conditions are recorded by the on-board computer. This
information is referred to as freeze frame data. View
Freeze Data is a snapshot of the operating conditions at
the time of an emission-related fault. View Freeze Data
can be overwritten by faults with a higher priority. If
codes were erased, View Freeze Data may not be stored
in vehicle memory depending on vehicle.