en | 2 6 | User guide |
OBD 2220
Info Scan
580000 | REV. A | 04.2017
Bosch Automotive Service Solutions Inc.
From Diagnostic Menu:
1. Select View Freeze Data.
•
Use the
and
keys until View Freeze
Data is highlighted.
•
Press
.
Diagnostic Menu
Read Codes
Erase Codes
MIL Status
State OBD Check
View Data
Record Data
View Freeze Data
Drive Cycle Monitor
Rd\Er
I/M Monitors
2. Select frame, if more than one frame is present.
•
Use the
and
keys until the desired
frame is highlighted.
•
Press
.
Select Data to View
Long PID Names
English/Metric
P2122 (MOD $09)
Rd\Er
3. View PID on scan tool.
Trouble Code that caused Freeze
TROUB CODE
FUEL SYS 1
FUEL SYS 2
CALC LOAD(%)
COOLANT(°C)
ST FTRM1(%)
LT FTRM1(%)
MAP(KPa)
ENG SPEED(RPM)
P2122
N/A
N/A
0.0
-40
0.0
0.0
177.0
0
VEH SPEED(KPH)
0
•
Use the
and
keys.
•
See “7 Appendix A—PID Definitions” on page
33 for PID definitions.
•
If Long PID Names is turned on, the expanded text
for the PID will scroll on the bottom line of the
display. See “Long PID Names” on page 11.
4. Select another frame to view (if available).
•
Press
.
5. Return to Diagnostic Menu.
•
Press
.
5.9
Drive Cycle Monitor
The Drive Cycle Monitor function is very similar to I/M
Monitors though the Drive Cycle Monitor is used to
view real-time operations of the emissions system on
OBDII vehicles. Drive Cycle Monitor continuously
updates as the vehicle reports operations of the emis-
sion system.
CAUTION
Two people must be in vehicle when driving.
One to drive and the other to operate the
scan tool.
•
Refer to the vehicle service manual for the drive
cycle operation.
Drive Cycle Monitor can be used if you want to drive the
vehicle until all of the monitors are OK.
During normal driving conditions, the vehicle computer
scans the emission system. After a specific amount of
drive time (each monitor has specific driving conditions
and time requirements), the computer monitors will
decide if the vehicle emissions system is working cor-
rectly or not as well as detecting out a range of values.
When the monitor status is:
•
“ok” - vehicle has been driven enough for function.
•
“inc” (incomplete) - vehicle was not driven enough
to complete all of the monitors.
•
“n/a” (not applicable) - vehicle does not support
that monitor.
Reset monitors by:
•
Erasing codes.
•
Vehicle computer module losing power (on some
vehicles).
From Diagnostic Menu:
1. Select Drive Cycle Monitor.
•
Use the
and
keys until Drive Cycle
Monitor is highlighted.
•
Press
.
Diagnostic Menu
Read Codes
Erase Codes
MIL Status
State OBD Check
View Data
Record Data
View Freeze Data
Drive Cycle Monitor
O2 Monitor Tests
Rd\Er
•
Two types of drive cycle monitors are:
