|
OBD 1100
| Operating instructions | 5
en
574114 REV B | 08.2018
Bosch Automotive Service Solutions
PENDING
Pending codes are reported
when a problem occurs during
the current or last completed
drive cycle .
PERMANENT
Permanent codes are a special
type of confirmed code that
only the vehicle can erase .
x / y
Appears only when view-
ing codes . Indicates code se-
quence and quantity (code x
of y) . For example, “2 / 9” indi-
cates that the 2nd of 9 codes
reported by the computer mod-
ule is being viewed .
ABS $##
Mod $##
Appears only when viewing
codes . Indicates the computer
module that reported the code .
ABS will appear if the code is
an ABS code . Mod $## appears
when the code is a powertrain
code . The Mod $## is the name
assigned to the vehicle control
module reporting the code .
Indicates that the
READ and
ERASE hot keys are active
Connect the Tool
To connect the tool to the vehicle:
1 . Locate the OBD II connector
under the steering column . If
the connector is not there, a
label should be there indicat-
ing the whereabouts of the
connector . For more informa-
tion on OBD II connectors, go
to http://www .obdclearing-
house .com/oemdb .
2 . If necessary, remove the cover
from the vehicle connector .
3 . Turn the ignition switch to
the ON position . Do not start
the engine .
4 . Plug the OBDII connector
attached to the tool into the
vehicle connector .
The Tool automatically reads
Codes and displays the data .
When done viewing data,
press
ENTER key to return
to Diagnostic Menu .
NOTICE
If the vehicle returns a
manufacturer specific
code, the tool will ask
if you wish to select
the vehicle and then
read ABS codes .
If the vehicle doesn’t
return a manufacturer
specific code, the tool
will ask if you wish
to select a vehicle to
read ABS codes . ABS
is not supported for
all vehicles .
Diagnostic Menu User
Interface
To select functions:
1 . From the Diagnostic Menu,
press the
READ or
ERASE
arrow key until the desired
function is highlighted, then
press
ENTER to retrieve and
display the results .
