7
Operating instructions
Burner locations
1
Pan supports
2
Control knobs
3
Auxiliary burner (up to 1 kW)
4
Rapid burner (up to 3 kW)
Accessories
Depending on the model, the hob may include the following
accessories. These can also be acquired from the Technical
Assistance Service.
--------
The manufacturer accepts no liability if these accessories are
not used or are used incorrectly.
Operation
There are indications to show which burner each control knob
operates.
It is essential to ensure that all the burner parts and pan
supports are correctly installed for the appliance to work
correctly. Do not swap the burner caps around.
Switching on automatically
If your hob can be switched on automatically (ignition
sparkers):
1.
Press the chosen burner control knob and turn it
anticlockwise to the maximum power setting.
While the control knob is still pressed down, sparks are
produced on all burners. The flame ignites.
2.
Release the control knob.
3.
Turn the control knob to the required setting.
If it does not come on, turn the control knob to the off setting
and repeat the steps above. This time, press and hold the
control knob for longer (up to 10 seconds).
:
Risk of deflagration!
If after 15 seconds the flame does not ignite, switch off the
burner and open a nearby window or door. Wait at least one
minute before trying to switch the burner back on.
Safety system
Depending on the model, your hob may have a safety system
(thermocouple) that prevents the flow of gas if the burners
accidentally switch off.
To ensure that this device is active:
1.
Switch on the burner as usual.
2.
Without releasing the control knob, press and hold it down
firmly for 4 seconds after lighting the flame.
Switching off a burner
Turn the corresponding control knob clockwise to the 0 setting.
Additional coffee maker
support
Only for use on the auxiliary
burner with pans which are no
more than 12 cm in diameter.
3&''$
2
1
LJQLWLRQVSDUNHU
WKHUPRFRXSOH
