background image

8

Power levels

The progressive control knobs can be used to control the 

power needed, from minimum to maximum power.

Warnings

It is normal to hear a soft whistling noise while the burner is 

operating.
When first used, it is normal for the burner to give off odours. 

This does not pose any risk and does not indicate a 

malfunction. They will disappear in time.
An orange-coloured flame is normal. This is caused by the 

presence of dust in the atmosphere, spilt liquids, etc.
If the burner flames are accidentally blown out, switch off the 

burner operating control knob and do not try to relight it for at 

least 1 minute.
A few seconds after the burner is switched off, a sound (thud) 

will be produced. This is not a fault - this means that the safety 

device is no longer operating.
Keep the burner as clean as possible. If the ignition sparkers 

are dirty they will not light properly. Clean them periodically 

using a small non-wire brush. Bear in mind that the ignition 

sparkers must not suffer any serious impacts.
Use “Large” setting to bring the pan to the boil, then adjust the 

flame between “Large flame” and “Economy flame” to maintain 

the required pan temperature.
Important: 

The use of a cooktop leads to the production of heat and 

moisture in the kitchen. For this reason make sure that the 

room is properly ventilated. Keep natural ventilation openings, 

such as windows, open or provide a mechanical ventilation 

device (e.g. a range hood or overhead exhaust fan). An orangy 

flame is normal and simply indicates the presence of salt in the 

atmosphere (from cooking). If the flame has yellow patches, 

this is not a fault (of any kind).

Cooking recommendation

Cooking pans

Suitable pans

The chart below gives the correct pan usage for each burner.

Precautions for use

The following advice is intended to help you save energy and 

prevent pan damage:

Setting

Û

Control off

Large flame

Maximum capacity or aperture and elec-

tricity on

Economy flame

˜

Minimum capacity or aperture

Burner

Very high - High Medium

Low

Rapid burner Escalopes, 

steaks, ome-

lettes, frying

Rice, white 

sauce, ragout

Steaming: 

fish, vegeta-

bles

Auxiliary 

burner

Cooking: casse-

roles, rice pud-

ding, caramel

Defrosting 

and slow 

cooking: veg-

etables, fruit 

and frozen 

products

Melting: but-

ter, choco-

late, jelly

Do not place anything, eg. 

flame tamer, asbestos mat, 

between pan and pan support 

as serious damage to the 

appliance may result.

Do not remove the pan support 

and enclose the burner with a 

wok stand as this will 

concentrate and deflect heat 

onto the hotplate.

Do not use large pots or heavy 

weights which can bend the 

pan support or deflect flame 

onto the hotplate.

Burner

Minimum pan 

diameter

Maximum pan 

diameter

Rapid burner

22 cm

26 cm

Auxiliary burner

12 cm

16 cm

Use pans which are the right 

size for each burner.
Do not use small pans on 

large burners. The flame must 

not touch the sides of the pan.

Do not use damaged pans, 

which do not sit evenly on the 

hob. Pans may tip over.
Only use pans with a thick, flat 

base.

Do not cook without using a lid 

and make sure the lid is 

properly fitted. This wastes 

energy.

Always centre the pan over the 

burner, not to one side. 

Otherwise it could tip over.
Do not place large pans on the 

burners near the control knobs. 

These may be damaged by the 

very high temperatures.
Place the pans on the pan 

supports, never directly on the 

burner.
Make sure that the pan 

supports and burner caps are 

correctly positioned before 

using the appliance.
Pans should be placed on the 

hob carefully.
Do not strike the hob and do 

not place excessive weight on 

it.

Summary of Contents for PCD345DA












Reviews: