Installation
Before connecting the unit, check whether the local
connection conditions (type of gas) are compatible with
the unit’s setting. Observe any special conditions imposed
by local suppliers (utilities). The specifications of this
cooktop are stated on the data label located on the
bottom of the cooktop base.
an accessible location near the hotplate if the data
A duplicate data label is supplied for adhesion to
accessed when the hotplate is installed.
label on the base of the hotplate cannot be
30
30
Pressure
test point
130
80
Pressure
test point
NAT GAS
1
min 30
Gas inlet
connection
30
30
130
80
Pressure
test point
NAT GAS
95
30
1a
520
min.
Gas inlet
connection
min.
520
Pressure
test point
min. 150
min. 150
Universal LPG
Universal LPG
This installation must conform with the following:
• Manufacturer’s Installation instructions
• Local Gas Fitting Regulations
• Municipal Building Codes,
• AGA Installation Code for Gas Burning Appliances.
• S.A.A. Wiring Code
• Local Electrical Regulations
• Any other statutory regulations
These built-in hobs are intended to be inserted in a
benchtop cutout.
Only an officially authorised technician should connect
the appliance.
Preparing to
install
I n s t a l l a t i o n d i m e n s i o n s a r e s h o w n i n F i g . 1
.
(AS 5601 - 2004 - Gas Installations).
Statutory
requirements
Refer to the AGA Installation Code for piping size details.
Before you begin, turn off the gas and electricity supply.
min 30 / m
ax 60
min 30 / max 60
6
