English |
23
Bosch Power Tools
1 609 929 L54 | (18.2.08)
Filling in Spray Material (see figures B1
–
B2)
f
Before any work on the machine itself, pull
the mains plug.
–
Unscrew the container
11
from the spray
gun.
–
Turn the suction tube
10
so that the spray
material can be sprayed with almost no resi-
due:
–
Fill the spray material into the container and
screw the container firmly to the spray gun.
Starting Operation
f
Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
f
Pay attention that the power tool cannot
draw in dust or other contamination during
operation.
Switching On
–
Plug the mains plug into a socket outlet.
–
Grasp the power tool and point it at the
spray surface.
The power tool is equipped with a two-step trig-
ger switch
16
. The first step starts the turbine.
The second step transports the spraying materi-
al.
–
Pull the trigger switch
16
until spraying ma-
terial starts to come out.
Switching Off
–
Release the trigger switch
16
.
–
Pull the mains plug from the socket outlet.
Working Advice
Spraying (see figures C–D)
Note:
Observe the wind direction when operat-
ing the power tool outdoors.
–
Firstly, carry out a test-spray run and adjust
the spray pattern and the spray material
quantity according to the spray material. (For
adjustments, see the following sections)
–
Make sure to hold the spray gun vertical to
the spray object at a uniform clearance be-
tween 5
–
15 cm.
–
Begin the spraying procedure outside the tar-
get area.
–
Move the spray gun evenly cross-wise or up-
and-down, depending on the spray pattern
setting.
An even surface quality is achieved when the
paths overlap by 4
–
5 cm.
–
Avoid interruptions inside the target area.
An even movement of the spray gun results in an
even surface quality.
Non-uniform clearance and spray angle lead to
heavy formation of paint mist and thus to an un-
even surface.
–
End the spraying procedure outside the tar-
get area.
Never spray the container completely empty.
When the suction tube no longer immerses in
the spray material, the spray jet will break off,
resulting in a non-uniform surface.
When coating material builds up on the nozzle
and air cap, clean both parts with the corre-
sponding solvent.
Note:
Only place down the power tool on a level
and clean surface so that it can not tip over.
For spray jobs on
horizontal surfaces
/objects
toward the
front
in
nozzle direction
For spray jobs
overhead
toward the
rear
in
handle direction
OBJ_BUCH-670-001.book Page 23 Monday, February 18, 2008 2:16 PM
