10
Care and cleaning
The advice and warnings contained in this section aim to guide
you in cleaning and maintaining the hob, so that it is kept in the
best possible condition
Hob
Cleaning
Clean the hob after each use. This prevents food remains left
on the surface from burning. Wait until the hob is cold enough
before attempting to clean it.
Only use cleaning products specifically designed for glass-
ceramic hobs. Follow the instructions provided on the
packaging.
Do not use:
■
Abrasive products
■
heavy-duty cleaners, like oven sprays and stain removers
■
Pads that may scratch
■
High-pressure or steam cleaners
Glass scraper
Remove dried-on food remains using a glass scraper.
1.
Release the scraper safety catch
2.
Use the blade to clean the hob surface
Do not attempt to clean the hob surface with the base of the
scraper. This could result in scratching.
ã=
Risk of injury!!
The blade is extremely sharp. Risk of cuts. Protect the blade
when not in use. Replace the blade immediately when any
imperfections are found.
Care of the appliance
Apply an additive to protect and preserve the hob. Follow the
advice and warnings provided with the product.
Hob frame
In order to avoid damage to the hob frame, follow the
indications below:
■
Use only slightly soapy hot water
■
Do not use sharp or abrasive products
■
Do not use a glass scraper
Fixing malfunctions
Malfunctions are commonly due to small details. Before calling
the Technical Assistance Service, you should consider the
following advice and warnings.
Indicator
Malfunction
Solution
none
The electric power supply has been inter-
rupted.
Use other electrical appliances to check whether there has been a
power cut.
The appliance has not been correctly con-
nected according to the connection dia-
gram.
Check that the appliance has been connected correctly according to
the connection diagram.
Electronic system malfunction.
If the above checks do not resolve the malfunction, contact the Tech-
nical Assistance Service.
“
flashes
The control panel is damp or an object is
resting on it.
Dry the control panel area or remove the object.
Ҥ
+ number /
š
+ number /
¡
+ number /
Electronic system malfunction.
Turn the hob off from the mains. Wait 30 seconds or so and switch it
back on.*
”‹
/
”Š
There is an internal error in the operation. Turn the hob off from the mains. Wait 30 seconds or so and switch it
back on.*
”ƒ
The electronic system has overheated and
the corresponding hotplate has been
switched off.
Wait for the electronic system to cool down. Then push any symbol
on the hob.*
”…
The electronic system has overheated and
all the hotplates have been switched off.
” ‰
The hotplate has been working non-stop
too long at a high power level.
The automatic time stop has been activated. Press any symbol on the
control panel. The indicator goes out. The hob may now be switched
back on.
—‚
Incorrect supply voltage, outside normal
operating limits.
Please contact the local electricity board.
—ƒ
/
—„
The hotplate has overheated and has
switched off in order to protect its cooking
surface.
Wait until the electronic system has cooled down sufficiently before
switching the hotplate back on.
* If the indication persists, call the Technical Assistance Service.
Do not rest hot pans on the control panel.
