English |
19
Line laser
PLL 1 P
Dimensions (length × width × height)
154 × 24 × 30 mm
A) The working range may be reduced by unfavourable environmental conditions (e.g. direct sun-
light).
B) when the measuring tool is positioned correctly(see "Positioning the Measuring Tool (see fig-
C) Only non-conductive deposits occur, whereby occasional temporary conductivity caused by
condensation is expected.
The serial number
(8)
on the type plate is used to clearly identify your measuring tool.
Assembly
Inserting/Replacing Batteries (see figure A)
It is recommended that you use alkaline manganese batteries to operate the measuring
tool.
To open the battery compartment cover
(10)
, push it away from the battery compart-
ment in the direction of the arrow. Insert the batteries.
When inserting the batteries, ensure that the polarity is correct according to the illustra-
tion on the inside of the battery compartment.
Always replace all the batteries at the same time. Only use batteries from the same man-
ufacturer and which have the same capacity.
u
Take the batteries out of the measuring tool when you are not using it for a pro-
longed period of time.
The batteries can corrode and self-discharge during pro-
longed storage in the measuring tool.
Operation
Starting Operation
u
Protect the measuring tool from moisture and direct sunlight.
u
Do not expose the measuring tool to any extreme temperatures or variations in
temperature.
For example, do not leave it in a car for extended periods of time. In
case of large variations in temperature, allow the measuring tool to adjust to the ambi-
ent temperature before putting it into operation. The precision of the measuring tool
may be compromised if exposed to extreme temperatures or variations in temperat-
ure.
u
Avoid substantial knocks to the measuring tool and avoid dropping it.
Damaging
the measuring tool can cause accuracy to be compromised. If the laser line is subjec-
Bosch Power Tools
1 609 92A 56S | (26.08.2019)
