Customer Service
en
11
Fault
Cause and troubleshooting
Short and weak
flame.
Low gas pressure.
▶
Open the gas valve fully, or replace the gas cylinder.
Long and yellow
flame.
Burner openings are blocked.
▶
Clean the burner openings.
Red flame.
Gas supply contains impurities, or the ambient air is damp.
No action required.
The kitchen smells of
gas.
Aging gas pipe or leaking joint.
▶
Open windows for ventilation, then contact customer service.
Burner does not ignite.
▶
Open windows for ventilation, then re-ignite.
11 Customer Service
If you have any queries on use, are unable to rectify
faults on the appliance yourself or if your appliance
needs to be repaired, contact Customer Service.
Detailed information on the warranty period and terms
of warranty in your country is available from our after-
sales service, your retailer or on our website.
If you contact Customer Service, you will require the
product number (E-Nr.) and the production number
(FD) of your appliance.
The contact details for Customer Service can be found
in the enclosed Customer Service directory or on our
website.
11.1 Product number (E-Nr.) and production
number (FD)
You can find the product number (E-Nr.) and the pro-
duction number (FD) on the appliance's rating plate.
Make a note of your appliance's details and the Cus-
tomer Service telephone number to find them again
quickly.
12 Installation instructions
Observe this information when installing the appliance.
12.1 Safe installation
Follow these safety instructions when in-
stalling the appliance.
The appliance can only be used safely if it is
correctly installed according to the safety in-
structions. The installer is responsible for en-
suring that the appliance works perfectly at its
installation location.
WARNING ‒ Risk of injury!
Parts that are accessible during installation
may have sharp edges and may lead to cut-
ting injuries.
▶
Wear protective gloves
WARNING ‒ Risk of fire!
The gas hob becomes very hot, other objects
may ignite.
▶
The gas hob should be installed at dis-
tance of at least 1 m to the kitchen ceiling.
WARNING ‒ Risk of explosion!
Escaping gas may cause an explosion.
▶
Only a licensed professional may connect
the appliance.
▶
Switch off the power and gas supply before
carrying out any work on the appliance.
▶
For the installation, observe the currently
valid building regulations and the regula-
tions of the local electricity and gas suppli-
ers.
▶
After connecting the appliance to the gas
supply, always check the connection for
leak tightness. The manufacturer accepts
no responsible for any gas leakage caused
by a third party due to gas installation.
Summary of Contents for PMD82D31 Series
Page 15: ......
