Bosch Professional GBH 18V-24 C Original Instructions Manual Download

Page: 24 / 343

| English

Working mode (22) indic-
ator

Functions

lights up

Favorite

working mode, the power tool can be individually configured via a smartphone

app.

– The speed can be configured in several settings for different applications:

low/medium/high (100 % of the maximum speed) speed

Practical Advice

The power tool with built-in

Bluetooth

Low Energy

Module

is equipped with a radio interface. Local oper-

ating restrictions, e.g. in aircraft or hospitals, must be
observed.

In areas in which the

Bluetooth

wireless technology

must not be used, the

Bluetooth

Low Energy Module

must be switched off via the app

Setting the drilling depth (see figure E)

You can use the depth stop

(14)

to set the required drilling

depth

– Press the button for depth stop adjustment

(5)

and insert

the depth stop into the auxiliary handle

(13)

The fluting on the depth stop

(14)

must face downwards.

– Insert the SDS-plus application tool into the SDS-plus tool

holder

(2)

to the stop. Otherwise, the movability of the

SDS-plus drilling tool can lead to incorrect adjustment of
the drilling depth.

– Pull the depth stop far enough out that the distance

between the drill bit tip and the edge of the depth stop
corresponds to the required drilling depth

Overload clutch

If the application tool jams or snags, the power trans-
mission to the drill spindle will be interrupted. Always
hold the power tool firmly with both hands to with-
stand the forces this may create and adopt a position
with stable footing.

Switch the power tool off immediately and remove the
application tool if the power tool becomes blocked.
Switching on when the drilling tool is blocked may
cause high torque reactions.

Rapid shut-off (KickBack Control)

The rapid shut-off function (KickBack
Control) gives the user greater control
over the power tool and offers them bet-
ter protection than power tools that do
not have Kickback Control. If the power
tool suddenly and unforeseeably rotates
around the drilling axis, it will switch off,
the rapid shut-off indicator

(19)

will light

up red and the worklight

(12)

will flash.

When rapid shut-off is activated, the
status indicator

(17)

flashes red.

– To

switch the tool back on

, release the on/off switch

(9)

and then press it again.

Inserting screwdriver bits (see figure F)

Only apply the power tool to the screw/nut when the
tool is switched off.

Rotating tool inserts can slip off.

A universal holder

(24)

with SDS-plus shank (accessory) is

required to work with screwdriver bits.
– Clean and lightly grease the insertion end of the shank.
– Insert the universal holder into the tool holder while turn-

ing it until it locks automatically.

– Check that it is locked by pulling the universal holder.
– Insert a screwdriver bit in the universal holder. Only use

screwdriver bits that fit the screw head.

– To remove the universal holder, slide the locking sleeve

(4)

backwards and remove the universal holder

(24)

from the tool holder.

Connectivity functions

System Requirements for Using the App

System Requirements

Mobile device (tablet,
smartphone)