12
| English
Pay attention to the dimensions of the abrasive tools.
Make sure that
both
X-LOCK catches are open (see figure
below) before fitting the X-LOCK application tool.
If necessary, clean the area between the two X-LOCK
catches.
Fitting the abrasive tool
➊
Place the grinding/cutting/flap disc in a central position
on the X-LOCK holder, parallel to the bearing surface
and with the right side facing up.
➋
Push the disc into the holder.
➌
The disc audibly clicks into place. Do not actuate the
lever
(3)
when doing so.
(3)
u
After fitting, check that the edge of the abrasive tool
(
➍
) is fitted correctly, i.e. is no higher than the refer-
ence surface (
➎
). If the edge is higher than the refer-
ence surface, either the holder must be cleaned or the
abrasive tool must not be used.
Before removing the grinding/cutting/flap disc:
Make
sure that the power tool has come to a complete stop.
Removing the abrasive tool
➊
Open the lever
(3)
.
➋
The grinding/cutting/flap disc will be released.
➌
The grinding/cutting/flap disc can be removed.
(3)
(3)
Cup brushes/disc brushes and fibre discs
u
Always fit the hand guard
(14) when working with the
cup brush/disc brush or fibre disc.
See the graphics page for fitting instructions.
To remove an application tool, open the lever
(3)
and re-
move the application tool.
Approved abrasive tools
You can use all the abrasive tools mentioned in these operat-
ing instructions.
The permissible speed [min
-1
] or the circumferential speed
[m/s] of the abrasive tools used must at least match the val-
ues given in the table.
It is therefore important to observe the permissible
rota-
tional/circumferential speed
on the label of the abrasive
tool.
Max. [mm]
[mm]
D
b
d
[min
-1
]
[m/s]
125
7
–
11.000
80
125
–
–
11.000
80
75
30
–
11.000
45
82
–
–
11.000
80
Rotating the Machine Head
u
Remove the battery from the power tool before carry-
ing out work on the power tool (e.g. maintenance,
changing tool, etc.). The battery should also be re-
moved for transport and storage.
There is risk of injury
from unintentionally pressing the on/off switch.
1 609 92A 6CZ | (14.07.2021)
Bosch Power Tools
Summary of Contents for Professional GWX 180-LI
