Power Supply
Installation | en
15
Bosch Security Systems
Installation manual
AR18-10-B002 | v1.1 | 2011.10
2.5
Connecting the output cables
Figure 2.4
Connecting the output cables
Connect the two output cables as follows:
–
Cut back the insulation of the cable wires to approximately
5 mm (0.2 in).
–
Pass the output cables through the supplied grommets.
–
For each wire, push back the tab behind the terminal with
a small screwdriver and insert the wire (respect the
polarity shown in the figure); release the tab to clamp the
wire in place.
–
Secure the grommets firmly.
–
Return the protective cover to its position and fasten in
place with the four cross-head screws.
Note:
Tighten screws firmly to ensure protection against water
ingress.
5 mm
(0.2 in)
