Operating the appliance
en
15
7.
Touch the
t
symbol for at least four seconds.
The settings are saved.
8.
Use the main switch in order to exit the basic
settings.
The display of the electronic controller is switched to air
recirculation mode.
1
Operating the appliance
Operating
the appl
iance
This chapter explains how to set a hotplate. The table
shows heat settings and cooking times for various
meals.
:
Warning – Risk of burns!
The metal filter cover will get very hot very quickly if left
on the hob. Never set the filter cover down on the hob.
Do not place pots, pans or other hot objects on the filter
cover.
Note:
Switch on the extractor hood when you start
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.
Switching the hob on and off
The main switch is used to switch the hob on and off.
To switch on: Touch the
#
symbol. An audible signal
sounds. The symbols for the hotplates and the functions
available at this time light up. The
‹
.
‹
symbol lights up
next to the hotplates. The hob is ready to use.
To switch off: Touch the
#
symbol until the indicators
go out. The residual heat indicator remains lit until the
hotplates have cooled down sufficiently.
Notes
■
The hob will automatically switch itself off if all
hotplates have been switched off for more than
30 seconds and the ventilation system is off.
■
The selected settings are stored for 4 seconds after
the hob has been switched off.If you switch it back
on during this time, the hob will operate using the
stored settings.
Setting a hotplate
Set the required heat setting using the
ò
to
ê
symbols.
Heat setting
ò
= lowest setting.
Heat setting
ê
= highest setting.
Every heat setting has an intermediate setting. This is
marked in the control panel with the
Ê
symbol.
