Childproof lock
en
37
Declaration of Conformity
Robert Bosch Hausgeräte GmbH hereby declares that
the appliance with wireless temperature sensor function
meets the basic requirements and other relevant
provisions of the Directive 1999/5/EG.
A detailed R&TTE Declaration of Conformity can be
found online at www.bosch-home.com on the product
page for your appliance under "Additional documents".
The logos and the Bluetooth® brand are registered
trademarks and property of Bluetooth SIG, Inc. These
trademarks are used by Robert Bosch Hausgeräte
GmbH under licence. All other trademarks and brand
names are owned by the respective companies.
A
Childproof lock
Childproo
f lock
You can use the childproof lock to prevent children
from switching on the hob.
Activating and deactivating the childproof
lock
The hob must be switched off.
To activate:
1.
Switch on the hob using the main switch.
2.
Touch the
>
Š
symbol for approx. 4 seconds.
The
Š
symbol will be lit for 10 seconds.
The hob is now locked.
To deactivate:
1.
Switch on the hob using the main switch.
2.
Touch the
>
Š
symbol for approx. 4 seconds.
The lock is now released.
Childproof lock
With this function, the childproof lock automatically
activates when a hob is switched off.
Switching on and off
You can find out how to switch the automatic childproof
section
k
Wipe protection
Wipe prot
ection
If you wipe over the control panel while the hob is
switched on, settings may be altered. To avoid doing
this, you can use the hob's "Lock control panel for
cleaning" function.
To switch on: Touch the
>
symbol. An audible signal
sounds. The control panel is locked for 35 seconds.
You can now wipe over the surface of the control panel
without altering any settings.
To deactivate: The control panel will be unlocked once
35 seconds have elapsed. To release the function early,
touch the
>
symbol.
Notes
■
An audible signal sounds 30 seconds after
activation. This indicates that the function is about to
finish.
■
The cleaning lock does not lock the main switch. The
hob can be switched off at any time.
b
Automatic safety cut-out
Automatic
safety c
ut-out
If a hotplate operates for an extended period and no
settings are changed, the automatic safety shut-off is
activated.
The hotplate stops heating.
”‰
and the residual heat
indicator
œ
or
•
flash alternately in the hotplate display.
When you touch any symbol, the display switches off.
The hotplate can now be set again.
The point at which the safety shut-off becomes active
depends on which heat setting has been set (after 1 to
10 hours).