Operating the appliance
en
17
Intensive setting
Activate intensive mode to eliminate strong smells and
odours. In this mode, the extractor hood operates at its
maximum fan setting for a short time. After a short time,
it automatically switches back to a low setting.
Switching on
1.
Touch the
:
symbol.
2.
Touch the
á
symbol.
The
á
symbol lights up brighter and the line above the
á
symbol lights up. Intensive mode is now activated.
Note:
After eight minutes, the appliance automatically
switches back to fan setting
Š
.
Note:
After a few seconds, the settings area for the heat
settings will be displayed again.
Switching off
1.
Touch the
:
symbol.
2.
Slide your finger over the settings area until setting
‹
or another setting is displayed.
Automatic start
Depending on the basic settings selected, the following
options will be available once you have selected the fan
setting for a cooking zone:
■
The ventilation system will not start.
■
The ventilation system will start at the fan setting
selected by the sensor.
■
The ventilation will start at a specified fan setting.
Select the option you want to use in the basic settings.
The basic settings also offer the option to adjust the
sensitivity of the sensor.
Automatic mode with sensor control
Switching on
1.
Touch the
#
symbol.
2.
Touch the
w
symbol.
The optimum setting is set automatically using a
sensor. The lines above the
w
symbol and the
:
symbol light up brighter.
Switching off
Touch the
w
symbol.
The line above the
w
symbol is not longer lit. Automatic
mode with sensor control is switched off.
Note:
The ventilation system will run at the fan setting
set by the sensor.
Run-on function
The run-on function leaves the ventilation system
running for a few minutes after it has been switched off.
This eliminates any remaining cooking smells. The
ventilation system will switch off automatically
afterwards.
In the basic settings, you can select the following
options for the run-on:
■
Deactivate the run-on
■
Activate the automatic function with sensor-
controlled run-on
■
Activate the run-on for a fixed period at a fixed fan
setting
Note:
If at least one cooking zone has been switched
on for at least one minute, the run-on is automatically
switched on.
If the automatic function with sensor-controlled run-on
has been activated, the
w
symbol and the line above
the
w
symbol will be lit during the run-on period.
Switching off
Touch the
:
or
w
symbol.
This will deactivate the run-on function immediately.
If one of the following conditions is present, the run-on
function is switched off:
■
The run-on time has expired.
■
The appliance is switched on again.
■
When the automatic function is activated with a
sensor-controlled run-on, the sensor determines a
corresponding room-air quality level.
Chef's recommendations
Recommendations
■
When heating up puree, cream soups and thick
sauces, stir occasionally.
■
Set heat setting 8 to 9 for preheating.
■
When cooking with the lid on, turn the heat setting
down as soon as steam escapes between the lid
and the cookware. Steam does not need to escape
for a good cooking result.
■
After cooking, keep the lid on the cookware until you
serve the food.
■
To cook with the pressure cooker, observe the
manufacturer's instructions.
■
Do not cook food for too long, otherwise the
nutrients will be lost. The kitchen clock can be used
to set the optimum cooking time.
■
For a more healthy cooking result, smoking oil
should be avoided.
