Cleaning
en
43
Hob
Clean the hob each time you use it. This will prevent
food remnants from becoming burned on. Do not clean
the hob until the residual heat indicator has gone out.
Remove boiled-over liquids immediately and do not
allow any food remains to dry on.
Clean the hob with a damp dish cloth and dry it with a
cloth or towel to prevent limescale build-up.
Stubborn dirt is best removed with a glass scraper or
glass ceramic cleaner (available from retailers). Follow
the manufacturer's instructions.
You can obtain a suitable glass scraper (article no.
00087670) from our after-sales service or through our
online shop.
Using a special sponge for cleaning glass-ceramic
hobs achieves great cleaning results.
Ventilation system
The filter must be regularly cleaned or replaced in order
to guarantee efficient filtration of odours and grease.
Metal grease filter
The metal grease filters should be cleaned every 30
operating hours or at least once a month.
:
Warning – Risk of fire!
Grease deposits in the grease filter may catch fire.
Clean the grease filter at least once a month.
Never operate the appliance without the grease filter.
Activated charcoal filters
The activated charcoal filter should be replaced
regularly. The saturation indicator on your appliance will
tell you how frequently this needs to be done.
Saturation display
If the metal grease filter or activated charcoal filter
becomes saturated, a signal will sound once the
appliance has been switched off.
The following symbols will light up in the display panel:
■
Metal grease filter:
”‚
‹
lights up
■
Activated charcoal filter:
”
‚‚
lights up
■
Metal grease filter and activated charcoal filter:
”
‚‹
and
”‚‚
light up alternately
Do not wait any longer to clean the metal grease filter or
replace the activated charcoal filter.
Changing the activated charcoal filter (only in
circulating-air mode)
Activated charcoal filters trap the odour-causing
compounds in cooking smells. They are only used for
circulating-air mode.
Notes
■
The activated charcoal filter is not included with the
appliance.The activated charcoal filter (article
no. HEZ381700) is available from specialist
retailers, from our after-sales service or from our
online shop.
■
The activated charcoal filter cannot be cleaned or
reactivated.
■
Only use genuine replacement filters. This will
ensure that the appliance performs optimally.
1.
Unlock all of the closing elements on the drawer in
the flat duct of the fitted unit.
2.
Open the drawer in the flat duct and remove the
activated charcoal filter.
3.
Insert the new activated charcoal filter.
4.
Close the drawer in the flat duct and lock all of the
closing elements.
Note:
Make sure that all of the closing elements
have been locked correctly. Otherwise noises may
be generated and the power of the ventilation
system may be reduced.