7 Parameter level
This section describes the available parameters and their configuration options. A parameter list for a quick
overview of all parameters can be found in the next chapter (
8). Customer-specific settings can be added
there.
Parameters
Configuration options
P01: Counting direction
Change of the counting direction. (0: forwards, 1: backwards)
P02: Display measurement unit
Display of the measurement unit.
0 = mm; 1 = inch; 2 = m; 3 = degrees; 4 = rpm; 5 = no measurement unit
P03: Decimal point
Definition of the decimal point (0 = 1 / 1 = 0.1 / 2 = 0.01 / 3 = 0.001).
P05: Keyboard lock
0 = off; 1 = on
P06: Edge evaluation*
Adjustment of the edge evaluation.
Range: Evaluation of 1 / 2 / 4 edges (0: x 1, 1: x 2, 2: x 4)
P07: Measuring system*
0 = incremental for IMS-C TTL
P08: Multiplication factor
Definition of the multiplication factor.
Range: 00.00001 … 99.99999
P10: Tool offset
Definition of the tool offset.
Range: 000000.1 … 999999.9
P11: Saw blade
Adjustment of the saw blade thickness.
Range: 0000.1 … 9999.9
P16: Default initialization*
Reset to factory parameters. (0: not init., 1: default init.)
Enter "1" in this parameter and confirm with the "Incr/Abs" key. Then, switch off the
device. After switching the device on again, the factory parameters have been
uploaded and the device has been reset.
P17: Function of external input 1
The corresponding external input can be programed as follows:
0 = external input 1 has no function
1 = set actual value to reference value (P09)
2 = set actual value to 0
P18: Function of external input 2
The corresponding external input can be programed as follows:
0 = external input 2 has no function
1 = add the tool offset (P10) (only if P19=0)
P19: Trigger for external input 1
0 = level-sensitive (high); 1 = edge-sensitive (positive)
P20: Display mode
0 = standard; 1 = rotation speed; 3 = angle
P99: Software version
This parameter displays the software version
*) Switch the device off and on again
Table 3:
Parameters
R320103179/2019-12
| IMScompact position display
Bosch Rexroth AG
11/18
