5 Installation and initial commissioning
NOTE
Please read the operating instructions carefully before commissioning the device! Notes on
installation must be observed! In case of damage caused by non-observance of these operating
instructions, the warranty expires.
Rexroth shall assume no liability for consequential damages! We also do not assume any liability
for personal injury, damage to property or financial losses!
The operator must take and implement appropriate security-relevant measures.
Commissioning
must only be performed by qualified personnel authorized and instructed by the
operator.
5�1
Operating area
WARNING!
Do not use the device in an explosive or corrosive environment!
The device must not be installed close to interference sources which have strong inductive
or capacitive interference or strong electrostatic fields!
CAUTION!
Electrical connections must be made by appropriately qualified personnel in accordance with
local regulations.
The device may be designed for switchboard mounting. During work on the switchboard,
all components must be de-energized if there is a danger of touching energized parts!
(Protection against accidental contact)
Wiring work must only be performed in de-energized state!
Thin cable strands have to be equipped with cable-end sleeves!
Before switching on the device, all connections and plug connectors have to be checked!
The device must be mounted so that it is protected against harmful environmental influences
such as splashing water, solvents, vibrations, shocks and severe pollution and that the operating
temperature is maintained.
8/18
Bosch Rexroth AG
IMScompact position display | R320103179/2019-12
