12/60
Safety instructions
Bosch Rexroth AG, A10VOH Series 60, RE 92704-01-B/2020-01-21
WARNING
Escaping hydraulic fluid mist!
Risk of explosion and fire hazard, health hazard, risk of environmental pollution!
▶
Depressurize the relevant machine/system component and repair the leak.
▶
Only perform welding work when the machine/system is depressurized.
▶
Keep open flames and ignition sources away from the axial piston unit.
▶
If axial piston units are located in the vicinity of ignition sources or
powerful thermal radiators, a shield must be erected to ensure any
escaping hydraulic fluid cannot be ignited, and to protect hose lines from
premature aging.
Electrical voltage!
Danger to life or risk of injury due to electric shock or property damage!
▶
Always disconnect the voltage supply to the relevant machine/system part
before installing the product and/or connecting or disconnecting the connector.
Protect the machine/system against being re-energized.
Limitation of the closed loop control and/or open loop control function!
Risk of injury or property damage!
Under certain circumstances, moving parts in control equipment (e.g., valve spools)
can get stuck in an undefined position due to contamination (e.g., impure
hydraulic fluid, abrasion or residual dirt from components). As a result, the
hydraulic fluid flow and the build-up of torque in the axial piston unit can no longer
respond correctly to the operator’s specifications. Even the use of various filter
elements (external or internal flow filtration) will not rule out a fault but merely
reduce the risk.
▶
Check whether your application requires remedial measures on your machine in
order to bring the driven consumer to a safe position (e.g. safe stop).
▶
If necessary, make sure these are appropriately implemented.
Escaping hydraulic fluid through leaking machine/system components!
Risk of burning and risk of injury due to escaping hydraulic fluid jet!
In case of leakage at the axial piston unit, high-pressure
fluid jets may escape.
▶
Depressurize the relevant machine/system component and repair the leak.
▶
Never attempt to block or seal the leak or hydraulic fluid jet with a cloth.