Safety instructions 13/56
RE 91706-01-B/09.2015, A10VER Series 52,
Bosch Rexroth AG
wARnInG
Escaping oil mist.
Risk of explosion and fire, health hazard, risk of environmental pollution.
▶
Depressurize the relevant machine/system part and repair the leak.
▶
Only perform welding work then the machine/system is depressurized.
▶
Keep open flames and ignition sources away from the axial piston unit.
▶
If axial piston units are located in the vicinity of ignition sources or powerful
thermal radiators, a shield must be erected to ensure that any escaped hydraulic
fluid cannot be ignited, and to protect hose lines from premature aging.
Electrical voltage!
Risk of injury from electric shock or risk of property damage.
▶
Always set up the relevant part of the machine/system so that it is free of electrical
voltage before you install the product or when connecting and disconnecting
connectors. Protect the machine/system against being re-energized.
Restriction of the control function.
Risk of injury or property damage.
Moving parts in control equipment (e.g., valve spools) can, under certain
circumstances, get blocked in position as a result of contamination (e.g., impure
hydraulic fluid, abrasion, or residual dirt from components). As a result, the flow
of hydraulic fluid and the build-up of momentum in the axial piston unit can no
longer meet the operator's specifications. Even the use of different filter cartridges
(external or internal inlet filter) will not rule out a fault but merely reduce the risk.
▶
Check whether remedial measures for your application are needed on your
machine in order to put the driven consumer in a safe state (e.g., safe stop).
▶
If necessary, make sure that these are properly implemented.
