Transport and storage 23/56
RE 91706-01-B/09.2015, A10VER Series 52,
Bosch Rexroth AG
6 Transport and storage
▶
Always observe the required ambient conditions for transport and storage, see
Chapter 6.2 “Storing the axial piston unit” on page 25.
Information on unpacking can be found in Chapter 7.1 “Unpacking” on page 27.
6.1 Transporting the axial piston unit
The following transportation options are available depending on the weight and
duration of transport:
•
Transporting by hand
•
Transporting with a lifting device (eye bolt or lifting strap)
Table 6: Dimensions and weights
Size
30
37
45
Weight
kg
18
18
18
Width
mm Dimensions vary by equipment. The values applicable for your axial piston
unit can be found in the installation drawing (request if necessary).
Height
mm
Depth
mm
Weight may vary by equipment.
6.1.1 Transporting by hand
Axial piston units with a weight of up to 15 kg can be transported manually for a
short time if necessary.
CAUTIOn.
Danger from heavy loads.
Health hazard from carrying axial piston units.
▶
Use suitable lifting, lowering and moving methods.
▶
Wear your personal protective equipment (e.g., safety goggles, safety gloves,
suitable working clothes, safety shoes).
▶
Do not use sensitive attachments to transport the axial piston unit (e.g., sensors
or valves).
▶
Carefully place the axial piston unit on the seating to prevent it from being damaged.
6.1.2 Transporting with a lifting device
For transporting, the axial piston unit can be connected to a lifting device via an eye
bolt or a lifting strap.
The axial piston unit can be transported suspended from an eye bolt screwed into
the drive shaft as long as only outward (pulling) axial forces are applied.
▶
For all female threads, use a stud end from the same system of units and of the
correct size.
▶
To do this, screw an eye bolt completely into the female thread on the drive shaft.
The thread size is stated in the installation drawing.
Dimensions and weights
Transport with eye bolt
