30/56 Installation
Bosch Rexroth AG
, A10VER Series 52, RE 91706-01-B/09.2015
7.4 Installing the axial piston unit
7.4.1 Preparation
1.
Check the specifications on the name plate of the axial piston unit to see if the
axial piston unit is correct.
2.
Compare the material number and designation (type code) with the details in the
order confirmation.
If the material number for the axial piston unit does not correspond to the one in
the order confirmation, contact Bosch Rexroth Service for clarification, see
Chapter 10.5 “Spare parts” on page 46.
3.
Before installing, completely empty the axial piston unit to prevent mixing with
the hydraulic fluid used in the machine/system.
4.
Check the permissible direction of rotation of the axial piston unit (on the name
plate) and make sure that this corresponds to the direction of rotation of the
intended motor function.
L
R
Fig. 8: Direction of rotation
R
Clockwise (cooling operation; counter-clockwise: reversing operation)
l
Counter-clockwise (upon request) (counter-clockwise: cooling operation;
clockwise: reversing operation)
The direction of rotation as specified on the name plate determines the direction
of rotation of the axial piston unit as viewed on the drive shaft, see
Chapter 5.3 “Product identification” on page 22.
7.4.2 Dimensions
The installation drawing contains the dimensions for all connections and ports on
the axial piston unit. Also observe the manuals provided by the manufacturers of the
other hydraulic components when selecting the required tools.
7.4.3 General instructions
Follow these general instructions when installing the axial piston unit:
