10/56
Safety instructions
Bosch Rexroth Corporation
, A21VG Series 10, RE 93223-01-B/09.2020
•
If unsuitable products are installed or used in applications that are of relevance
to safety, unexpected operating conditions may occur in the application, which
could result in personal injury or property damage. For this reason, only use
the product in safety-relevant applications if this use is expressly indicated
and approved in the product documentation, e.g. in explosion protection areas
or in safety-related parts of a control system (functional safety).
•
Only commission the product if it has been determined that the end product (e.g.
machinery/system) in which the Rexroth products are installed complies with the
country-specific provisions, safety regulations and standards for the application.
•
Use tools appropriate for the work being performed and wear appropriate
protective clothing to prevent punctures and cuts (e.g. when removing protective
covers, disassembly).
•
There is a risk of entanglement when operating the axial piston unit with
a bare shaft end. Check whether or not your machine requires additional safety
measures for your application. If necessary, make sure these are appropriately
implemented.
•
Depending on the type of control used, electromagnetic effects can be produced
when using solenoids. Applying a direct voltage signal (DC) to solenoids does not
create electromagnetic interference (EMI) nor is the solenoid affected by EMI.
Potential electromagnetic interference (EMI) exists if the solenoid is energized
with a modulated direct current (e.g. PWM signal). Appropriate testing and
measures should be taken by the machine manufacturer to ensure other
components or operators (e.g. with pacemaker) are not affected by this potential.
