26/64
Transport and storage
Bosch Rexroth AG, A4VG Series 35, RE 92035-01-B/2019-11-25
Only use the lifting strap if you are unable to achieve the required installation
position by transporting with the eye bolt.
The axial piston unit can be transported suspended from an eye bolt screwed into
the drive shaft as long as only outward (pulling) axial forces are applied.
▶
For all female threads, use a stud end from the same system of units and of the
correct size.
▶
To do this, screw an eye bolt completely into the female thread on the drive shaft.
The thread size is indicated in the installation drawing.
▶
Make sure that the eye bolt can bear the total weight of the axial piston unit
plus 20%.
You can lift the axial piston unit as shown in Fig. 5 with the eye bolt screwed into the
drive shaft.
Fig. 5: Mounting the eye bolt
▶
For all female threads, use a stud end from the same system of units and of the
correct size (M8).
▶
Screw an eye bolt fully into the female thread in the housing.
▶
Make sure that each eye bolt can bear the total weight of the axial piston unit
plus approx. 20%.
You can lift the axial piston unit as shown in Fig. 6 with the eye bolt screwed into the
housing.
Fig. 6: Mounting eye bolts in housing
Transporting with
eye bolt in drive shaft
Transporting with
eye bolt in housing
(possible in standard
version without swivel
angle monitoring)
