Bosch rexroth ctrlX AUTOMATION, Quick Start Manual

5

ctrlX AUTOMATION First Steps

Intended use

Bosch Rexroth AG

R911403760 Edition 01

2

Important directions for use

2.1

Intended use

2.1.1

Introduction

Rexroth products are developed and manufactured to the state-of-the-art.
The products are tested prior to delivery to ensure operational safety and relia-

bility.

WARNING

Personal injury and property damage by using products

incorrectly!
The products may only be used as intended.
Failure to use the products in the intended way may

cause situations resulting in property damage and per-

sonal injury.

NOTICE

Damages resulting from unintended use
Rexroth as the manufacturer shall not honor any war-

ranty, liability or compensatory claims for damages

resulting from unintended use of the products. The user

alone shall bear the risks of unintended use of the prod-

ucts.
Before using Rexroth products, make sure that all the

prerequisites for an intended use of the products are sat-

isfied:

−

Personnel that in any way, shape or form uses Rexroth

products must first read and understand the relevant

safety instructions and be familiar with their intended

use

−

Leave hardware products in their original state, i.e.,

do not make any structural modifications. It is not

permitted to decompile software products or alter

their source codes

−

Do not install damaged or faulty products or put them

into operation

−

Make sure that the products have been installed as

described in the relevant documentation

2.1.2

Areas of use and application

Products of the ctrlX series are suitable for Motion/Logic applications.

NOTICE

Products of the ctrlX series may only be used with the

accessories, mounting parts, and other components

specified in this documentation. Components that are

not expressly mentioned may neither be attached nor

connected. The same applies to cables and lines.
Only to be operated with the hardware component con-

figurations and combinations expressly specified and

with the software and firmware specified in the corre-

sponding documentations and functional descriptions.

Products of the ctrlX series are suitable for single-axis as well as for multi-axis

drive and control tasks. Device types with different equipment and interfaces

are available for using the system in specific applications.