Bosch Rexroth Corp., Model HAB..-7X,
RA 50175-B/07.2016
1 About this documentation
1.1
Scope and purpose
This documentation applies to the following products:
• Hydraulic bladder and diaphragm accumulators.
This documentation is intended for installation personnel and machinery/plant users or
manufacturers.
This documentation contains important information for proper and safe installation and
operation of the product and for troubleshooting simple errors oneself.
▶
Before commencing any work with the product, be sure to read these Instructions
carefully and completely.
1.2
Required and amending documentation
▶
Only commission the bladder-type accumulator type HAB..-6X if you have been provided
with the documentation marked with the book symbol
and you have understood and
observed it.
Table 1: Required and amending documentation
Title
Document number
Document type
Bladder-type accumulator, type HAB, component series 7
Technical data, operating conditions, performance limits and project planning
information concerning bladder-type accumulators type HAB..-7X
50175
Data sheet
Filling and testing device for accumulators
Describes the set-up and use of a filling and testing device for accumulators
50144-B
Operating
instructions
Hydraulic fluids based on mineral oils and related hydrocarbons
Describes the requirements on hydraulic fluids on mineral oil basis and related
hydrocarbons for operation with Rexroth hydraulic components and helps you to
select a hydraulic fluid for your hydraulic system
90220
Data sheet
General product information on hydraulic products
Contains general information on hydraulic products
07008
Operating
instructions
Installation, commissioning and maintenance of hydraulic systems
Contains general information on the installation, commissioning and maintenance
of hydraulic systems
07900
Data sheet
The bladder-type accumulator type HAB..-7X is a system component.
▶
Also observe the instructions for the other system components and the system
manufacturer’s documentation.
1.3
Presentation of information
To enable users to work rapidly and safely with the product while following these Instruc-
tions, this documentation uses standardized safety instructions, symbols, terms and defini-
tions, and abbreviations. These are explained in the following sub-sections.
1.3.1
Safety instructions
These Instructions contain safety instructions preceding any actions that involve a risk of
personal injury or damage to property. The safety precautions described must be adhered to.
Safety instructions are structured as follows:
SIGNAL WORD
Type and source of hazard!!
Consequences if ignored.
▶
Hazard avoidance precautions.
6
About this documentation
