RA 50175-B/07.2016,
Model HAB..-7X
,
Bosch Rexroth Corp.
Please note that the warranty period is not prolonged by the storage time.
The claim to warranty expires in case of non-compliance with the requirements and
storage conditions or after expiry of the maximum storage time.
Please note that, according to the provisions and ordinances valid in your country,
the test intervals mostly refer to the date of manufacture and are also not prolonged
by the storage time.
8.2
Storage of the bladder-type accumulator
The bladder-type accumulators are supplied with a primer coat of paint. The machine end-
user must ensure a sufficient corrosion protection during storage.
• Ensure that the storage facilities are free from etching substances and gases.
• Optimum storage temperature: +5 °C to +20 °C. Ensure a constant temperature, if possible.
• Protect the bladder-type accumulator against impacts during storage.
• Ensure that the cover cap at the gas valve and the protective cap at the oil valve are
attached.
The maximum storage time of the bladder-type accumulator amounts to 5 years.
Procedure after expiration of maximum storage time:
▶
Carry out a visual inspection of the bladder-type accumulator and check for any damage
and corrosion.
▶
After the expiration of the maximum storage time, have the complete bladder-type
accumulator checked by an expert, see chapter 2.4 „Qualification of personnel“.
▶
After the expiration of the maximum storage time, have the bladder, seals and gas valve
insert exchanged by an expert, see chapter 2.4 „Qualification of personnel“.
Requirements
Maximum storage time
Commissioning after storage
21
Transport and storage
