7.
●
Remove the battery from the cover by loosening the four M3
screws, see
fig. 8-4 "Position of the four M3 screws" on page 50
.
1
①
Fastening screws of the battery
Fig.8-4:
Position of the four M3 screws
Dispose the battery immediately and properly. Observe the notes given
in this chapter and in
chapter 10 "Environmental Protection and Dispos‐
8.
●
Battery damage due to inadequate
screws.
NOTICE
Attach the new battery by using the four original M3 screws. A lon‐
ger screw might damage the housing of the battery.
●
Observe that only a battery which is permitted by Bosch Rexroth is
installed, e. g. the battery "AKKU24V/2,5Ah" (Bosch Rexroth parts
number: 1070923287).
●
Tighten the four M3 screws (see
fig. 8-4 "Position of the four M3
) with a torque of 6.2 lbf in (0.7 Nm).
9.
Plug the battery connector until it clicks into place.
10.
●
Close the cover
●
Attach the cover with the original M5x10 Z4 screw to the housing
by tightening it with a torque of 24.8 lbf in (2.8 Nm).
11.
Refit fuse F1.
Bosch Rexroth AG
DOK-SUPPL*-VAU*01.1U**-PR03-EN-P
Rexroth IndraControl VAU 01.1U UPS with USB interface
50/63
Maintenance, Storage and Transport
