requirements of safe work practices. They must have adequate safe‐
ty equipment and be trained in first aid.
●
Only use spare parts and accessories approved by the manufacturer.
●
Follow all safety regulations and requirements for the specific application
as practiced in the country of use.
●
The devices have been designed for installation in industrial machinery.
●
The ambient conditions given in the product documentation must be ob‐
served.
●
Only use safety-relevant applications that are clearly and explicitly ap‐
proved in the Project Planning Manual. If this is not the case, they are
excluded.
The following areas of use and application, for example, include satety
features and applications: Construction cranes, elevators used for people
and freight, devices and vehicles to transport people, medical applica‐
tions, refinery plants, transport of hazardous goods, nuclear applications,
applications in which electrical devices with vital functions can be electro‐
magnetically disturbed, mining, food processing, control of protection
equipment (also in machine).
●
The information given in the documentation of the product with regard to
the use of the delivered components contains only examples of applica‐
tions and suggestions.
The machine and installation manufacturer must
–
make sure that the delivered components are suited for his individual
application and check the information given in this documentation
with regard to the use of the components,
–
make sure that his application complies with the applicable safety
regulations and standards and carry out the required measures,
modifications and complements.
Commissioning of the delivered components is only permitted once it is sure
that the machine or installation in which they are installed complies with the
national regulations, safety specifications and standards of the application.
●
Operation is only permitted if the national EMC regulations for the appli‐
cation are met.
●
The instructions for installation in accordance with EMC requirements can
be found in the documentation "EMV in Drive and Control Systems".
The machine or installation manufacturer is responsible for compliance
with the limiting values as prescribed in the national regulations.
●
Technical data, connection and installation conditions are specified in the
product documentation and must be followed at all times.
3.5
Protection Against Contact with Electric Parts
This section only concerns devices and drive components with vol‐
tages of more than 50 Volt.
Contact with parts conducting voltages above 50 volts can cause personal
danger and electric shock. When operating electrical equipment, it is unavoid‐
able that some parts of the units conduct dangerous voltage.
Project Planning Manual | Rexroth IndraControl VAU 01.1Z
Electric Drives
and Controls
| Bosch Rexroth AG
9/45
Safety Instructions for Electric Drives and Controls
