4
-6
Bosch Rexroth AG
| Electric Drives and Controls
Rexroth IndraControl VCP 35.2
|
R911323106
/
02
Technical Data
4.8
Applied Standards and Guidelines
4.9
Compatibility Test
All Rexroth controls and drives are developed and tested according to
the technological state-of-the-art.
As it is impossible to follow the continuing development of all materials
(e.g. lubricants in machine tools) which may interact with our controls
and drives, it cannot be completely ruled out that any reactions with the
materials used by Bosch Rexroth might occur.
Standards and Guidelines
Interference Immunity
EN 61000-4-2
EN 61000-4-3
EN 61000-4-4
EN 61000-4-5
EN 61000-4-6
EN 61000-6-2
Emitted Interference
EN 55022 Limit Value Class A
EN 6100-6-4
Equipment Requirements
EN 61131
Storage and Transportation
EN 61131 Part 2
Power Supply
EN 61131 Part 2
Electromagnetic Compatibility
89/336/EEC (Including all Applicable Amendments)
Degrees of Protection
EN 60529
Impact Load, Shocks
EN 60068 Part 2-27
Sinusoidal Vibrations
EN 60068 Part 2-6
UL/CSA-Certification
UL508 (Industrial Control Equipment)
C22.2 No. 14-95 (CSA)
This is a class A device. This device may cause radio interference in
residential areas. In this case, the user may be required to introduce ap-
propriate countermeasures, and to bear the cost of same.
You must satisfy the following conditions for a operation in conformity
with the UL/CSA:
•
Only use isolated copper wires for at least 60/75 °C (140/167 °F)
•
Only use isolated wires of class 1.
The UL/CSA identification only applies to the device in the delivery
state. After changes at the device e.g. after putting additional expansion
boards the UL conformity must be checked.
Summary of Contents for Rexroth IndraControl VCP 35.2
Page 63: ......
