NOTICE
In case of non-compliance with this safety instruction, material damage can
occur.
3.3 Symbols used
Pointers are displayed as follows:
This is a note.
Tips are displayed as follows:
This is a tip.
3.4 Explaining the signal alert symbol on the device
krax
If this symbol is on your device, you have to observe the documentation
on the device. The respective documentation informs on the type of
hazard as well as the steps required to avoid this hazard.
4 Intended use
The Bosch Rexroth operator displays are passive operator and visualization ter-
minals. They form a PC-based operator terminal when used with a Bosch
Rexroth control cabinet PC.
Risk of damaging the device if not expressly sta-
ted accessories, mounting parts and other com-
ponents, cables, lines and software and firm-
ware are used.
NOTICE
The operator displays may only be used as intended and with the accessories,
mounting parts and other components specified in this documentation. Compo-
nents that are not expressly mentioned must neither be attached nor connected.
The same applies to cables and lines.
Only to be operated with the component configurations and combinations ex-
pressly defined and with the software and firmware specified in the correspond-
ing functional description.
Typical areas of application of the operator display:
Bosch Rexroth AG
Intended use
DOK-SUPPL*-VDPXX.3MTBU-IT03-EN-P
5/37
