Rexroth IndraDrive
Handling, Diagnostic and Service Functions
10-15
DOK-INDRV*-GEN-**VRS**-WA01-EN-P
Fault Report
for Drive Systems
Date:
Report No.:
Page 2 of 2
General conditions:
Mode at time fault occurred:
Parameterization mode
Operating mode
Switch phase
Operating mode active at time fault occurred: ,
Encoder ,
7-segment display...
...before fault occurred:
...after fault occurred:
Fault status
occurs permanently
occurs during commissioning
occurs sporadically
occurs after approx. hours
occurs with shocks
depends on temperature
Causes
unknown
incorrect connection
external cause
mechanical damage
loose cable connection
moisture in unit
foreign body in unit
Other defects
problems in the mechanical system
power section failure
control system failure
motor failure
cable break
defective blower
defective feedback
Wiring / mechanical setup
(e. g. length of cables, grounding, assembly,...):
Information on the machine
(e. g. operating hours, type, serial number,...):
Mains conditions
(e. g. frequency, voltage,...):
Ambient conditions
(e. g. ambient temperature, humidity,...):
In case of problems with DriveTop
Name of the dialog in which the fault occurred:
Drive connection:
Note:
In order to resolve your DriveTop problem quickly, we would like to ask you to send us the file "debug.log". You
can find it in the DriveTop directory.
Fig. 10-2:
Fault Report (Page 2 of 2)
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
