MKEmotors must only be used with the accessories specified in
this documentation. Components that are not explicitly mentioned
must neither be attached nor connected. The same is true for ca‐
bles and lines.
The operation must only be carried out in the explicitly mentioned
configurations and combinations of the component and with the
software and firmware specified in the corresponding functional
description.
Any connected drive control device must be programmed before startup in or‐
der to ensure that the motor executes the functions specifically to the particu‐
lar application.
MKEmotors may only be operated under the assembly, mounting and instal‐
lation conditions, in the normal position, and under the environmental condi‐
tions (temperature, degree of protection, humidity, EMC etc.) specified in this
documentation.
2.2
Inappropriate Use
Any use of MKE motors outside of the fields of application mentioned above
or under operating conditions and technical data other than those specified in
this documentation is considered to be "inappropriate use".
MKE motors may not be used if . . .
●
Ambient conditions require a higher explosion protection than indicated
at the motor type plate.
●
They are subject to operating conditions which do not comply with the
ambient conditions described above. For example, they must not be op‐
erated under water, under extreme temperature fluctuations or extreme
maximum temperatures.
●
The intended application is not explicitly released by Bosch Rexroth.
Please make absolutely sure that the instructions given in the general
safety notes are also complied with!
Bosch Rexroth AG
DOK-MOTOR*-MKE*GEN2***-PR06-EN-P
Rexroth MKE Synchronous Motors for Potentially Explosive Areas acc. to ATEX and UL/CSA
12/135
Important Instructions on Use
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
