![background image](http://html.mh-extra.com/html/bosch/rexroth-mobilex-gft-w-30-series/rexroth-mobilex-gft-w-30-series_operating-instructions-manual_40588032.webp)
32/86
Assembly
Bosch Rexroth AG
, MOBILEX GFT-W general operating instructions series 30, RE 79100-01-B/11.2020
The dimensioned drawing contains the dimensions of all connections of the
MOBILEX GFT-W planetary gearbox. Also observe the instructions of the
manufacturers of the mounting parts in appendix C “Mounting parts” in the
material number-specific operating instructions.
5
Remove the preservative from the outside flange surfaces with a suitable
organic solvent (e.g. HAKUTEX 74) or an alkaline detergent (e.g. HAKUPUR
236). Wear suitable protective gloves and protective goggles when cleaning the
planetary gearbox and observe the manufacturer's safety notes when handling
preservative or solvents. These data sheets are not included within Rexroth's
scope of supply.
NOTE
Damages to the seals!
Aggressive detergents or solvents can damage the seals of the planetary gearbox
and can cause the seals to age faster!
When removing the preserving agent make sure that no aggressive detergents
or solvents enter the seal areas. This applies in particular to the area of the
output seals.
7.5.2
Installing the planetary gearbox with assembled axial-piston motor into
the equipment frame or winch base/cable drum
If the MOBILEX GFT-W planetary gearbox is supplied together with the axial-piston
motor, the axial-piston motor is mounted on the planetary gearbox. Depending on
the existing opening in the equipment frame or winch base, the axial-piston motor
has to be removed from the planetary gearbox prior to assembly.
CAUTION
Failure or damage to the planetary gearbox!
Depending on the design of the planetary gearbox, the carrier may be pulled out
of the disk gearing of the static multiple-disk parking brake. This may result in a
multiple-disk brake failure!
When assembling the planetary gearbox, make sure that the carrier and the
disks are in the same position as shown in the spare parts drawing, view “A”,
in appendix D “Technical data / Drawings” of the material number-specific
operating instructions.