1
Internal gear pump PGH5
1.1
ISO4017-M16X40-8.8 (tightening torque 210 Nm)
1.2
ISO7090-16-200HV
1.3
DIN580-M10
2
Adapter flange
3
Pump foot (option)
3.1 / 3.3 ISO7090-16-200HV
3.2
ISO4762-M16X70-8.8 (tightening torque 210 Nm)
3.4
ISO4032-M16-8
4
Synchronous motor MSK133
4.1
ISO7090-16-200HV
4.2
ISO4762-M16X40-8.8 (tightening torque 210 Nm)
4.3
DIN580-M12
5
Damping rail (option)
5.1
ISO4017-M10X30-8.8 (tightening torque 50 Nm)
5.2
ISO7089-10-200HV
Mount motor-pump unit MPA01 from components
The figure shows mounting of motors in design "SA" (air cooling). The
mounting of motors in "FN" design (liquid cooling) is identically.
1. Screw on damping rails (5) on the motor.
In case of design without damping rails, this mounting step is not
applied.
To reach the fastening holes, remove the lower air guides to
mount the damping rails in the case of motors with fan. Fasten
the damping rails (5) with the screws (5.1) and washers (5.2) on
the motor. Tightening torque 50 Nm, lock screw connection with
Loctite 243®. Remount the air guides.
2. Mount the adapter flange (2).
With design without adapter flange, this mounting step is not ap-
plied.
Screw the adapter flange (2) on the motor (4) with socket head
screws (4.2) and washers (4.1). Tightening torque 210 Nm, lock
screw connection with Loctite 243®.
3. Screw the pump with the motor.
Use adaquate lifting tools.
2
PGH5 - MSK133 - Air / Liquid Cooling | Motor-Pump Unit MPA01
Bosch Rexroth AG, Edition 03 , R911341600, DOK-SYTROX-MPA01*M13**-AS03-EN-P
